COLD PATCH 

---

Cold Patch is a 2 component repair and patching mortar for concrete floors at cold temperatures.  Cold Patch fills holes, repairs damage or resurfaces the entire floor.  This rapid setting patching material moves easily into hard to reach places. 

Cold Patch can be applied as thick as 6 inches down to a featheredge, and is ready for foot traffic in 4 to 8 hours.

Cold Patch can be applied in temperatures as low as –2C  (28 F) to +8C (46 F) in dry or wet environments.

Cold Patch won’t crack, shrink, or loose its bond when applied in cool temperatures.  For areas that are below –2C (28F) use Polar Patch.

FEATURES
Cures at low temperatures
No Shrinkage
Solvent Free
VOC Compliant
Easy to Trowel
Easy to Mix
Excellent Abrasion Resistance
Excellent Adhesion
Can be Applied with either a Smooth or Slip Resistant Texture

RECOMMENDED USE
Cold Patch is intended to be used on industrial plant floors, walls, loading docks, ramps to fill holes, repair damage or resurface. 

SPECIFICATIONS
UNIT SIZE:  50 lb kit
PACKAGING:  Plastic Pail
COVERAGE:  13 SQ FT at ½ inch thick
COLOR:  Cement Grey
WORKING TIME:  5 minutes
FOOT TRAFFIC:  4 to 8 hours
SHELF LIFE:  2 years in unopened container
APPLICATION TEMP:  -2C (28F) to +8C (46F)

APPLICATION
SURFACE PREPARATION
The surface must be clean, sound, and dry.  Remove all loose and disintegrated material.  Remove all types of oil, dirt, dust, mold or mildew, efflorescence, release and curing agents.

MIXING INSTRUCTIONS
Pour all of liquid component into a clean five-gallon pail and add the powder mixture and mix until smooth (approximately 1-2 minutes).
Place the mix. Maximum time for placement should not exceed 5 minutes.  Once placed, a broom finish can be done if required. 

CLEAN-UP
Clean all tools and equipment with water.  Cured material may be removed by mechanical means only.

Cornerstone Coatings International Inc.
Copyrite 2006  All Rights Reserved