CORNERSTONE COATINGS INTERNATIONAL INC.
Toll Free: 1.866.878.7069
P.O. Box 479 Bruno, SK CANADA S0K 0S0
CORNERSTONE COATINGS International Inc.
REPAIRING CONCRETE
TROWEL MASTER (EASY LEVEL)
From general purpose patching and repair to complete floor resurfacing, Trowel Master is the product to use. Often concrete surfaces can pop or shale off and there was not much of a solution except to tear out the whole pad and pay for a new one. With Trowel Master Easy Level you simply patch areas that need patching, and then roll on a new surface. Trowel Master has tremendous adhesion and tensile strength, and excellent water resistance to decrease spalling, cracking and surface degradation caused by freeze thaw cycles.
TROWEL MASTER (FAST SET) - All the same advantages of Trowel Master (Easy Level) but can be applied from 6 inches thick down to a feather edge.
ROLL MASTER (Roll on Overlay System)
This is a thin concrete overlay that can be rolled or trowelled over existing concrete to repair damaged areas or cover over existing concrete. Roll Master is non-slip and can be stained with Deco Stain or acid stain. Does not require moisture curing, it is air cured at ambient temperatures and relative humidity.
Typically most overlays last 4 years before delaminating. These delamination failures are the result of product failure, not workmanship. Roll Master is meant to be used on exterior high moisture environments and will not break down or delaminate. The high rate of success with Roll Master is attributed to using not only the best resin available, but the resin that was designed for exterior moisture environments.
Great product for walkways, pool decks, patios, driveways and more. Has excellent adhesion, strength, UV resistance and water resistance.
PROTEC III LSF RESTORE
Hardens and restores strength to old, carbonated, or poorly finished concrete slabs.
Highly porous surfaces such as pre-cast concrete and concrete slats exposed to harsh environments require the extra protection Protec III Restore provides. The service life of concrete in harsh environments will be lengthened due to the chemical and abrasion resistance this product gives to the concrete.
Protec III leaves the surface natural looking, and provides a non-slip surface where required. Meets LEED Requirements.
COLD PATCH (Cold Temperature Patching Material)
Cold Patch fills holes, repairs damage and can be used to resurface the entire concrete pad. Can be applied as thick as 6 inches down to a feather edge and is ready for foot traffic in 8 hours. It won't crack, shrink or loose its bond. Use in temperatures as low as -2C (28F) to +8C (46F). For areas that are below -2C (28F) use Polar Patch Freezer Repair.
